Re: Stainless PalmControl handle
The basic adapter is pretty simple - you could make one from a rubber stopper. You 'just' need to be able to turn it down to fit the hole in the SS handle and then drill a hole for the cylinder of the Classic without quite going through the top (it's that rubber 'cap' over the cylinder that makes it work).
Casting would probably be much easier and I'm sure it would be more mass producible. You just need to make a mold with a central cylinder matching the Classic's inside an outer cylinder matching the hole in the handle with the outer cylinder being about 1/16" taller so you get the smooth sealing layer across the top of the Classic's cylinder.
|