Engraving Forum.com - The Internet's Largest and Fastest Growing Engraving Community

Showing Visitor Messages 1 to 5 of 5

07-09-2010 09:39 AM
airamp

Thanks Jerry,

A Motorola and Intell used a lot of these.

Thanks,
Mike
07-09-2010 09:29 AM
jlseymour

Go to dovebid.com and search for microscopes and there's allot wild scopes in AZ coming up for auction...
Good luck I just got 2 Zeiss out of PA...
- View Conversation
10-29-2009 11:44 AM
jlseymour

Doc I just tried to hold the new low profile vice when you tilt, I've not got the toolbox rubber, but I took some sandpaper and ruffed it some and it seems to work some...
I only tried 400 grit but I think 320 or 220 would hold better, but you would have to do it depending on how much you moved the vise...
Is that thing heavy??? I'm someday going to have some help to move it from one place to another...
Hope to meetup some day...
Visit FL and visit the shop...
Jerry
- View Conversation
10-07-2009 02:32 AM
carsten bo

Hi. If i try to see your last post about dovetail wise, my virusblocker gets cracy and tells me that theres malware on your site. Is there any problems, or just a very sensitive virusblocker on my computer.
- View Conversation
02-21-2009 08:51 AM
jlseymour

Doc I've been looking for your post on your faceting mach for graver sharping...
I have the same one and don't have time to facet so I'd like to use it for different angles than standard...
Jerry
- View Conversation